Hello Gautam,
unfortunately job parameters cannot have their values changed once a job has been called.
If you need to have a changed value visible in your job you could use the value of a stage variable to indicate the recovery status within a transform stage - I'm not sure if that adresses your question.
If you don't need to reassign the value in the job directly, but just need to ensure that somewhere a flag is set so that the calling sequence or the next job see that you have recovered. Perhaps you could set a value in the hashed file indicating the recovery status, or create an empty sequential file when recovery is complete or use some similar mechanism.
Re-assigning a job parameter
Moderators: chulett, rschirm, roy
<a href=http://www.worldcommunitygrid.org/team/ ... TZ9H4CGVP1 target="WCGWin">
</a>
</a>
Re-assigning a job parameter
Thanks Arnd.
Using stage variable in the transformer seems to be a good option to go along with - I will definitely give it a try.
Thanks so much for your inputs.
Using stage variable in the transformer seems to be a good option to go along with - I will definitely give it a try.
Thanks so much for your inputs.
Gautam Handa