Hi,
You can find in the metadata definition a property called "Extended" try giving Unicode over there and check whether its working or not.
Regards
Naveen
Need Help in RCP jobs
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 36
- Joined: Thu Dec 03, 2009 9:11 pm
- Location: Malaysia
Re: Need Help in RCP jobs
Naveen Kumar
Datastage Consultant
Datastage Consultant
How much RCP are you using?
Are your columns surfaced anywhere? Or are the columns in question not specified throughout the entire job? Do you land the data to any temporary files? Are you using schemas to apply any metadata?
If they are not specified anywhere, then it is likely that any "unexpected results" are being caused by the metadata interpretation at either the source or target, any landed files, or via schemas. All these need to be checked.
Have you checked that your target can accept those characters? (ie just write a query to insert a test value).
Are your columns surfaced anywhere? Or are the columns in question not specified throughout the entire job? Do you land the data to any temporary files? Are you using schemas to apply any metadata?
If they are not specified anywhere, then it is likely that any "unexpected results" are being caused by the metadata interpretation at either the source or target, any landed files, or via schemas. All these need to be checked.
Have you checked that your target can accept those characters? (ie just write a query to insert a test value).
-
- Participant
- Posts: 4
- Joined: Mon Oct 12, 2015 3:48 pm
Re: Need Help in RCP jobs
Hi Naveen,
I donot have metadata defined in the job at all. The job does select * from Source. It's fully RCP so don't have any column in the metadata else I would have done that.
Thanks,
Surya
I donot have metadata defined in the job at all. The job does select * from Source. It's fully RCP so don't have any column in the metadata else I would have done that.
Thanks,
Surya
Surya
-
- Participant
- Posts: 4
- Joined: Mon Oct 12, 2015 3:48 pm
-
- Participant
- Posts: 4
- Joined: Mon Oct 12, 2015 3:48 pm