Hi Everyone,
We're working with a new install of 9.1.2 and during some initial testing of a few parallel jobs we are noticing that the elapsed time is incorrect on all jobs. In the below example the job started yesterday afternoon and only ran for a few minutes. The finished time was a value that didn't yet exist and the elapsed time showed 5 hours 4 minutes 22 seconds. The actual run time was only a couple of minutes. Has anyone experienced this before or can anyone point us to a location that we need to look further into? Thank you!
Incorrect Elapsed Time
Moderators: chulett, rschirm, roy
The behavior I have seen is that the log entry timestamp is NOT the time in which the event happened. It is the time in which the event was LOGGED. (there is a difference)
In your case... you should also look to see if you are running in a cluster and ensure that all of your servers are using the same timezone setting.
several hours worth of difference... (look for TZ setting)
In your case... you should also look to see if you are running in a cluster and ensure that all of your servers are using the same timezone setting.
several hours worth of difference... (look for TZ setting)