Hi,
Scenario: Sequencer which calls a parallel job has param problem.
In the sequencer, I have an execution_comand stage where I am using cat <file_name> to read a date value stored in the file. This stage is connected to a similar stage where I read another date from another file. Both These values are passed to the next Job_activity as Command_outputs. I have defined two job parameters (cur_job_dt and lst_adj_dt) for these date values. First time when I run, the job runs fine. But when I rerun the sequencer again, it fails with the following error message :
main_program: Parameter not resolvable: cur_job_dt
It throws the error for only cur_job_dt parameter and not for the other one.
Now if I rename cur_job_dt to cur_job_dt1 and run the sequencer it runs fine. But if I run again it fails.
Let me know if anybody faced same kind of problem..
main_program: Parameter not resolvable
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 22
- Joined: Fri Oct 15, 2004 11:53 pm
- Location: Bangalore, India
- Contact:
main_program: Parameter not resolvable
--------------
Subramanya
Subramanya
-
- Participant
- Posts: 37
- Joined: Tue Jan 29, 2008 6:03 am
- Location: Guntur
- Contact: