Hi All,
Can any one help me generate a UTF-8 file in DS 8.5
Also i need to check if it is a UTF-8 file or an ANSI file generated out of DS 8.5
I have tried to set up NLS as UTF-8 at property level and at stage level.
But when i open the file and do a save as i see the file encoding type as ANSI instead of UTF-8
How to generate a UTF-8 file in DS 8.5
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 137
- Joined: Sun Jan 07, 2007 11:17 pm
- Location: VISAKHAPATNAM
-
- Participant
- Posts: 137
- Joined: Sun Jan 07, 2007 11:17 pm
- Location: VISAKHAPATNAM
Hi ArndW
Thanks a lot for the reply..
We were using notepad,
Notepad is showing up the encoding type as UTF-8 after saving the mannually created sample file in UTF-8 but the file generated out of DS 8.5 do not show the file encoding type as UTF-8 instead it shows ANSI.
Do you mean we should not check it using notepad instead we should use Binary editor.
Regrds,
Shivaranjani.
Thanks a lot for the reply..
We were using notepad,
Notepad is showing up the encoding type as UTF-8 after saving the mannually created sample file in UTF-8 but the file generated out of DS 8.5 do not show the file encoding type as UTF-8 instead it shows ANSI.
Do you mean we should not check it using notepad instead we should use Binary editor.
Regrds,
Shivaranjani.