Hi,
I have a simple job with the following structure:
Netezza Source -> Transfomer -> Checksum -> Netezza Target
The Computation Mode for the Checksum is "Use all Columns except those specified"
However, upon running this job, I get the following error:
Checksum_Calculate,1: Internal Error: (!exportLog_->hasError()): checksum/checksum.C: 387
Traceback: Could not obtain stack trace; check that 'gdb' and 'sed' are installed and on your PATH
Can anyone please help me out with this ?
Checksum Stage Error
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 35
- Joined: Mon Nov 01, 2010 2:48 am
- Location: New Delhi
Checksum Stage Error
Arpit Chopra
Your best bet is your support provider. I would replace the Netezza source stage with a row-generator, the output with a peek stage and see if the problem persists, that way you will at least have an acceptable test-case for support.
How many columns and what datatypes are you doing the Checksum on?
How many columns and what datatypes are you doing the Checksum on?
-
- Participant
- Posts: 35
- Joined: Mon Nov 01, 2010 2:48 am
- Location: New Delhi
Unfortunately that is not the error code, but the source line number where the error was detected so doesn't help us any further. I've used that stage several times and have never had issue with it. You did define the output column as char(32), right?
Try to make a simple job with just 1 of those columns with a row generator to see if that works.
Try to make a simple job with just 1 of those columns with a row generator to see if that works.
-
- Participant
- Posts: 35
- Joined: Mon Nov 01, 2010 2:48 am
- Location: New Delhi
I tried what you suggested. In fact, I re-created this job from scratch.
And it started working !
Now this is strange. I didn't make any change to the logic/properties/anything and still it started working on its own.
Still not a solution though. I'll need to re-create all the jobs where I faced this error.
And it started working !
Now this is strange. I didn't make any change to the logic/properties/anything and still it started working on its own.
Still not a solution though. I'll need to re-create all the jobs where I faced this error.
Arpit Chopra