Hi DS Guru,
Have 10 jobs in one sequence , Out them 2 jobs are failed.
How to re-run my sequence , what condition have to used to re-run the whole sequence so that only failed jobs will run .
Have to run the whole sequcen, But only the jobs which are failed in the previous run those should run in the second time.
Thanks in advance !!
Regards,
John
How to Handle the Sequence Failure
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 42
- Joined: Mon Oct 15, 2007 10:35 pm
- Location: Charlotte
- Contact:
Re: How to Handle the Sequence Failure
These need to be achived based on the design / approach.
You need to choose the Add checkpoints so sequence is restartable on failure.
DS User
You need to choose the Add checkpoints so sequence is restartable on failure.
DS User
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
You don't necessarily have to add checkpoints but, if you don't, you have to design your own logic to determine whether each job failed on its previous run and make the decision to bypass it or to reset and run it. This would better handle the case where the sequence did not stop (was not programmed to stop) because of a failed job.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.