Hi
I have a master sequence and child sequence which is called by the master. The master sequence properties has its add checkpoints propety set.
The child sequence has two job activities and the child sequence properties is set to add checkpoints and all the job activities have their job run option set as Reset if required and run.
I had an abort in the child sequence job activities and i have fixed the problem. While i tried to restart the master sequence it is trying to run the child job sequence without resetting it and hence the master sequence breaks again...
Any clues what would be the problem ..?
Job Sequences Not restarting as expected
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 247
- Joined: Mon Jan 22, 2007 11:33 pm
Job Sequences Not restarting as expected
Regards
Ragu
Ragu
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
-
- Participant
- Posts: 247
- Joined: Mon Jan 22, 2007 11:33 pm
With checkpointing turned on in the 'child' sequences, you really don't want them to be reset as that will remove any checkpoints and rerun them from the beginning. I assume you want them to pick up from the aborted step, yes?
How exactly does 'the master sequence break again'?
How exactly does 'the master sequence break again'?
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers