Hi,
In my job i have created one sequencer,what i want is if i missed out to pass the value in sequencer parameter while running it,my sequencer should not run or it should abort.
Please help me on this.
Regards,
Sachin Gupta
Parameters in Sequencers
Moderators: chulett, rschirm, roy
It is possible. If a parameter gets added after a job sequence is built then it can run the job without that parameter. If the job being run has a default value on that parameter it will use the default otherwise it should fail.
Same is true using the dsjob command. Parameters can be left out if they have defaults and the job will run fine.
Same is true using the dsjob command. Parameters can be left out if they have defaults and the job will run fine.
Mamu Kim
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact: