Hi,
I have a sequencer and I am passing some parameter values manually to it.
What i want is, if suppose i forgot to pass value to any one parameter, my sequencer should not run or if runs it should abort immediately or should prompt me for every parameter.
Can we do this in sequencer without using any user defined routine.
Please help me on this.
Regards,
Sachin Gupta
Parameters Value In Sequencer
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
It would be an expression that evaluates to true or false, exactly the same as you would use in a Transformer constraint. When true, the trigger 'fires' and whatever is at the other end executes. You can check for failure condition(s) first and then use an Otherwise trigger for the good path or reverse that.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers