Hi,
I was doing a full extract from table and writing to a dataset, running the job on 4 node config file, But when I try to view the data using dataset management, Data is going to only one node??, I was trying to understand If there was any setting that I was missing?? Please help me understand this, Thanks in advance..
Data going to only one node.
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Unless you take steps to force it, less than 32KB of data will always go only to one node in a Data Set. 32KB is the smallest amount of data moved around by DataStage parallel engine.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.