Hi,
Changes made to the parameter set are not reflecting in the parallel jobs.
The parameter set has username,password& schema.
Below is the sequence of events where i am facing issue.
1) Compile & run the job successfully.
2) Change the password/schema name in the parameter set.
3) Run the job without compilation. The job fails in this step.
But if i recompile the job and run it then it runs successfully picking the changed password or schema name.
I am expecting the job to pick the changes to the parameter set during runtime. Is this possible without recompiling? If so is there any environment setting to acheive this?
Thanks in advance to everyone.
Change in paramter set not refelecting in the job.
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 19
- Joined: Mon Feb 14, 2005 11:34 pm
Re: Change in paramter set not refelecting in the job.
Try by removing the parameter set from the job and add it again..compile and run..
Re: Change in paramter set not refelecting in the job.
[quote="shivajid2k"]Try by removing the parameter set from the job and add it again..compile and run..[/quote]
The job runs fine if i compile and run it. The issue is with recompilation. I have a ton of jobs which use the parameter set. I am looking to avoide the recompilation whenever there is a change to the parameter set.
The job runs fine if i compile and run it. The issue is with recompilation. I have a ton of jobs which use the parameter set. I am looking to avoide the recompilation whenever there is a change to the parameter set.