Post questions here relative to DataStage Enterprise/PX Edition for such areas as Parallel job design, Parallel datasets, BuildOps, Wrappers, etc.
Moderators: chulett , rschirm , roy
vinsashi
Participant
Posts: 150 Joined: Mon Aug 20, 2007 4:52 am
Location: singapore
Post
by vinsashi » Thu Feb 25, 2010 5:09 am
Hi,
my job compiled and run in designer.but in director if i see view log i am not getting anything page getting blank.any thing i have to enable i checked all but not getting
Thanks
chulett
Charter Member
Posts: 43085 Joined: Tue Nov 12, 2002 4:34 pm
Location: Denver, CO
Post
by chulett » Thu Feb 25, 2010 6:21 am
Perhaps you're not looking at the correct log? It happens.
What happens if you run the job from Director?
-craig
"You can never have too many knives" -- Logan Nine Fingers
vinsashi
Participant
Posts: 150 Joined: Mon Aug 20, 2007 4:52 am
Location: singapore
Post
by vinsashi » Thu Feb 25, 2010 6:35 am
it showing status if job success then it showing finished like that .if i click on viewlog then it showing blank
Thanks
....
chulett
Charter Member
Posts: 43085 Joined: Tue Nov 12, 2002 4:34 pm
Location: Denver, CO
Post
by chulett » Thu Feb 25, 2010 6:38 am
And this is version 7, not 8, yes? And the job status changes like it should to Running and then some form of Finished? What do you see in the Monitor while it runs?
-craig
"You can never have too many knives" -- Logan Nine Fingers
ray.wurlod
Participant
Posts: 54607 Joined: Wed Oct 23, 2002 10:52 pm
Location: Sydney, Australia
Contact:
Post
by ray.wurlod » Thu Feb 25, 2010 3:50 pm
Does the dsjob -logsum command work correctly?
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.