Close command : parallel
Moderators: chulett, rschirm, roy
Close command : parallel
Just a quick question.
When I perform a close command and am running on 2 nodes, is this normal that the close command perform for EACH node and not only once after the load is completed ?
I use Oracle
Thanks
When I perform a close command and am running on 2 nodes, is this normal that the close command perform for EACH node and not only once after the load is completed ?
I use Oracle
Thanks
HI Algfr,
If you are using oracle enterprise stage to load or perform any operation on close command, it doesnt matter how many nodes you are using.
it will be executed once after completion of load operation.
Thanks,[/b]
If you are using oracle enterprise stage to load or perform any operation on close command, it doesnt matter how many nodes you are using.
it will be executed once after completion of load operation.
Thanks,[/b]
Regards,
Deepak Singhal
Everything is okay in the end. If it's not okay, then it's not the end.
Deepak Singhal
Everything is okay in the end. If it's not okay, then it's not the end.
-
- Participant
- Posts: 251
- Joined: Mon Jun 09, 2008 5:52 am
-
- Participant
- Posts: 152
- Joined: Tue Jan 13, 2009 8:59 am
[quote="DSguru2B"]That is wierd. Can someone reproduce this on 7.x ?
Get in touch with IBM and see what they have to say about it.[/quote]
it happened to me as well. i was inserting into some table on 4 nodes, and my job aborts saying " i was trying to insert duplicates" .
i am on 8.0.1 on AIX 5.3.
when i changed it to run on one node...job runs fine.
Regards.
Get in touch with IBM and see what they have to say about it.[/quote]
it happened to me as well. i was inserting into some table on 4 nodes, and my job aborts saying " i was trying to insert duplicates" .
i am on 8.0.1 on AIX 5.3.
when i changed it to run on one node...job runs fine.
Regards.
-
- Participant
- Posts: 152
- Joined: Tue Jan 13, 2009 8:59 am