How to run 2 jobs Parallel in JOB SEQUENCER
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
If you want them to start at the same time (plus or minus a second or two) you will need to write your own job control code with the two DSRunJob() calls adjacent. The code produced by a job sequence sets one job running before starting to set parameter values, etc. for the other.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
The OP has yet to post anything that looks like the actual start and end times of the jobs in question but rather has posted routine messages ("Dataset .. is deleted" ??) instead. I wouldn't make any judgments on what starts when until we see that. And we're just looking for a simple list:
Job name, start time, end time
For the three jobs in question.
Job name, start time, end time
For the three jobs in question.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers