Hi All
i ma getting the following error after I reset the abnormal termination in one of the job
DataStage Job 1062 Phantom 12580
jobnotify: Unknown error 911
DataStage Phantom Finished.
DataStage Job 1062 Phantom 12585
Abnormal termination of DataStage.
Fault type is 11. Layer type is BASIC run machine.
Fault occurred in BASIC program DSP.Open at address 574.
jOB DESIGN IS STRAIGHT FORWARD.
db-tx-db
Could anyone please shed light on this issue?
Thanks
Fault Type 11
Moderators: chulett, rschirm, roy
Fault Type 11
Pradeep Kumar
First bit of light shedding should come from a forum search. For example, I got 40 hits when I did an exact search for "Fault type is 11", something out there should help.
FYI - The "Fault types" are the same as UNIX signals, so 11 is SIGSEGV or a Segmentation Violation:
http://www.cs.pitt.edu/~alanjawi/cs449/ ... ignals.htm
FYI - The "Fault types" are the same as UNIX signals, so 11 is SIGSEGV or a Segmentation Violation:
http://www.cs.pitt.edu/~alanjawi/cs449/ ... ignals.htm
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Yes it can. A segmentation violation can occur for many causes, most of which your search would have revealed. If any of these causes occurs in future (for example an attempt to load 15 characters into a Char(12) field) then you will get a segmentation violation.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact: