Post questions here relative to DataStage Server Edition for such areas as Server job design, DS Basic, Routines, Job Sequences, etc.
Moderators: chulett, rschirm, roy
-
major
- Premium Member
- Posts: 167
- Joined: Mon Nov 26, 2007 12:21 am
Post
by major »
Hi,
I have a requirement in which a particular job need to run every 6 hrs, is there any provision in DataStage to do that.
Gone through scheduler but i think we cannot implement above req in it
Thanks in advance
-
chulett
- Charter Member
- Posts: 43085
- Joined: Tue Nov 12, 2002 4:34 pm
- Location: Denver, CO
Post
by chulett »
Sure - simply "Add to Schedule" every six hours for the days / time ranges you need.
-craig
"You can never have too many knives" -- Logan Nine Fingers
-
Magesh_bala
- Participant
- Posts: 86
- Joined: Mon Nov 27, 2006 3:42 am
- Location: Wilmington
Post
by Magesh_bala »
Hi, I belive we dont have an option in scheduler to run every six hours.
-
Magesh_bala
- Participant
- Posts: 86
- Joined: Mon Nov 27, 2006 3:42 am
- Location: Wilmington
Post
by Magesh_bala »
Hi, I belive we dont have an option in scheduler to run every six hours.
-
ray.wurlod
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
-
Contact:
Post
by ray.wurlod »
You do. It's called putting four entries into the scheduler interface with the times six hours apart and, perhaps, setting "every day".
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
chulett
- Charter Member
- Posts: 43085
- Joined: Tue Nov 12, 2002 4:34 pm
- Location: Denver, CO
Post
by chulett »
I wouldn't have suggested it if you couldn't do it.
It may not be obvious, but you can take a single job and 'Add to Schedule' as many times as makes sense.
-craig
"You can never have too many knives" -- Logan Nine Fingers
-
major
- Premium Member
- Posts: 167
- Joined: Mon Nov 26, 2007 12:21 am
Post
by major »
Thank you all for your suggestions ,
the logic is working :D