Teradata Connector Stage in Bulk mode
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 64
- Joined: Fri Jan 25, 2008 4:41 am
Teradata Connector Stage in Bulk mode
I have a source table in Teradata(table containing 5 rows) when i read it through Terdata Connector stage(TPT) setting "Access Method = immediate" then it gives the result in few second when i change the "Access Method = bulk" the job doesn't work i wait for it 5-10 min and it doesn't gives any result, do any body know if any parameters need to be set to use it in bulk mode. For the time being the configration file contain one node and the jobs hangs on the step "main program: Starting step execution"
-
- Participant
- Posts: 64
- Joined: Fri Jan 25, 2008 4:41 am
The jobs structure is
Teradata Connector - > SeqFile
Access Method = Bulk
Parallel Synchronization = No (Also tried with Yes but same result)
Most the properties are default, Whenever i read or wirte using AccessMethod = Bulk the jobs just hangs it doesn't give any error messgae or any output, so i am not able to figure out what might be the problem. Is this configration problem?, when i run a manual TPT script from the Unix machine it wors but from DS it hangs the job.
Teradata Connector - > SeqFile
Access Method = Bulk
Parallel Synchronization = No (Also tried with Yes but same result)
Most the properties are default, Whenever i read or wirte using AccessMethod = Bulk the jobs just hangs it doesn't give any error messgae or any output, so i am not able to figure out what might be the problem. Is this configration problem?, when i run a manual TPT script from the Unix machine it wors but from DS it hangs the job.
-
- Participant
- Posts: 64
- Joined: Fri Jan 25, 2008 4:41 am