Hi,
my datastage job contains two aggregators, output of the two aggregators are joined in a join stage with 'innerjoin' mode. when i run my job untill this join stage, it runs fine. i kept one transformer stage where i am calculating so many variables based on variables RATESAVG_1,RATESAVG_2,RATESAVG_3........RATESAVG_12. I am getting fatal error "main_program: Fatal Error: Destination "input0Int8RATESAVG_1122" is already bound". I dont have any variable with name "RATESAVG_1122", also my target variable is of type Decimal(13,4) not Int8.
please suggest
getting a fatal error in dstage job
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 13
- Joined: Mon Feb 18, 2008 7:28 am
getting a fatal error in dstage job
Nothing but something
Re: getting a fatal error in dstage job
Hi...
" i kept one transformer stage where i am calculating so many variables based on variables RATESAVG_1,RATESAVG_2,RATESAVG_3........RATESAVG_12."
I am not clear on, " calculating so many variable based on variables", Could you elaborate it bit. Are these 12 variables are calculated based on the output from join stage?
Thanks,
Senthil P
" i kept one transformer stage where i am calculating so many variables based on variables RATESAVG_1,RATESAVG_2,RATESAVG_3........RATESAVG_12."
I am not clear on, " calculating so many variable based on variables", Could you elaborate it bit. Are these 12 variables are calculated based on the output from join stage?
Thanks,
Senthil P
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact: