Folks,
I have a master sequencer that calls 5 sequences in that job.The job runs fine every night in prod,but Yday it failed.The reason is the master sequence is not able to call the one of the sequence contained in it.
This was the message
jsParent (@jschild5): Controller problem: Error calling DSRunJob(jschild5), code=-14
[Timed out while waiting for an event]
There is no watch for event in that parent job.
Again I re-ran the job this morning and all the jobs went well.
Still I'm not able to understand the reason behind the failure of the child job.Any ideas on this is greatly appreciated.
Thanks,
ETL
Error calling a DS job
Moderators: chulett, rschirm, roy
The error indicates that the engine requested a job run but the resouces were not available and hence the request timed out. This may happen if you are running one too many jobs at the same time and hence exhausting the resources.
Creativity is allowing yourself to make mistakes. Art is knowing which ones to keep.
Re: Error calling a DS job
Actually, it's more like 60 seconds.pradeepleon wrote:error token for -14 :DSJE_TIMEOUT The job appears not to have started after waiting for a reasonable length of time. (About 30 minutes.)
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers
![Confused :?](./images/smilies/icon_confused.gif)
Sheesh, don't take it personal - just pointing out that (regardless of where it came from) the information is incorrect.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers
-
- Participant
- Posts: 32
- Joined: Fri Dec 02, 2005 10:44 pm
- Location: Chicago,IL