Post questions here relative to DataStage Enterprise/PX Edition for such areas as Parallel job design, Parallel datasets, BuildOps, Wrappers, etc.
Moderators: chulett , rschirm , roy
bollinenik
Participant
Posts: 111 Joined: Thu Jun 01, 2006 5:12 am
Location: Detroit
Post
by bollinenik » Fri Mar 02, 2007 10:17 am
Hi,
I am doing hash partitioning in sortstage and it is gioiving below problem.
APT_CombinedOperatorController(2),0: sh: dbx: not found
kOTI,
1586-738-7785
DSguru2B
Charter Member
Posts: 6854 Joined: Wed Feb 09, 2005 3:44 pm
Location: Houston, TX
Post
by DSguru2B » Fri Mar 02, 2007 10:30 am
Search on the error message. I believe its been covered here before.
Creativity is allowing yourself to make mistakes. Art is knowing which ones to keep.
bollinenik
Participant
Posts: 111 Joined: Thu Jun 01, 2006 5:12 am
Location: Detroit
Post
by bollinenik » Fri Mar 02, 2007 10:58 am
yes.....I did that but there is no exact solution, just some discussions are happened earlier.......that's why I posted if have any idea pls share with me
Thanks in Advance
kOTI,
1586-738-7785
DSguru2B
Charter Member
Posts: 6854 Joined: Wed Feb 09, 2005 3:44 pm
Location: Houston, TX
Post
by DSguru2B » Fri Mar 02, 2007 11:02 am
Are you getting any additional warning messages. Reset the job and see if you get any messages "From Previour Run".
Creativity is allowing yourself to make mistakes. Art is knowing which ones to keep.
bollinenik
Participant
Posts: 111 Joined: Thu Jun 01, 2006 5:12 am
Location: Detroit
Post
by bollinenik » Fri Mar 02, 2007 11:06 am
yes.....I tried that also and I deleted that code and exported again still it's giving same problem
kOTI,
1586-738-7785