Hi,
I have 3 MS-DOS commands, which I want to run in parallel.
I approached like this:
Created a sequence.
Added 3 Command Stages to it and ran the commands.
The commands were triggerred in parallel as desired.
Due, to some reasons, I need to run the same commands from
a routine, so I approached like this:
Created a rotuine, which takes in the command ( with params ) as
the input arg, which calls DSExecute() to run the command.
Now, I created a new sequence.
Added 3 routine activity stages to it, passing the different commands as different parameters to the same routine.
But now, the 3 commands are not running in parallel now.
i.e the routine is not triggering parallely to run the 3 different input commands as desired.
Please explain.
Thanks and Regards.
Running DOS Commands parallely
Moderators: chulett, rschirm, roy
-
- Premium Member
- Posts: 273
- Joined: Wed Oct 18, 2006 12:20 pm
- Location: Porto
-
- Premium Member
- Posts: 273
- Joined: Wed Oct 18, 2006 12:20 pm
- Location: Porto
-
- Premium Member
- Posts: 273
- Joined: Wed Oct 18, 2006 12:20 pm
- Location: Porto
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact: