Hello,
I am relatively new to EE and am encountering the following error when attempting to view data from a sequential file stage and/or running a small job that reads/writes data from sequential files.
"main_program: Fatal Error: this APT_Locator is invalid: Empty locator"
Is this error due to an EE setup configuration miscue or to something not being properly set within the job?
Any help would be appreciated,
csimms
Invalid APT_Locator
Moderators: chulett, rschirm, roy
Invalid APT_Locator
Chris Simms
Mobile: +972 989 0919
Mobile: +972 989 0919
richdhan.richdhan wrote:Hi csimms,
Are you using the $APT_CONFIG_FILE environment variable as a job parameter? In the job parameter list move $APT_CONFIG_FILE parameter to the top of the list.
HTH
--Rich
First, thanks for responding. The error was in fact related to the APT_CONFIG_FILE. At some point after our EE installation (it did test ok at a point in time) a block point upgrade was performed on the server which had an apparent affect on our EE as APT_CONFIG_FILE was not being initialized. Once this issue was resolved, the error disappeared.
Thanks again,
Chris Simms
Mobile: +972 989 0919
Mobile: +972 989 0919
Hi Rich,richdhan wrote:Hi csimms,
Are you using the $APT_CONFIG_FILE environment variable as a job parameter? In the job parameter list move $APT_CONFIG_FILE parameter to the top of the list.
HTH
--Rich
Ever faced any issue with the order of the $APT_CONFIG_FILE environment variable in job properties grid
Impossible doesn't mean 'it is not possible' actually means... 'NOBODY HAS DONE IT SO FAR'