Hi All,
I am facing a problem with my DSDB2 Stage. The whole environment was set up recently. I am getting the following error when i select view data from the stage " ds_loadlibrary: error in dlopen ". We have installed DB2 Client on the ETL Server (AIX) and specified the LIBPATH and floowing environment variables in dsenv.
DB2DIR
DB2INSTANCE
INSTHOME
Will anyone be able to give some input to the above problem.
Thanks,
Tom.
Error from DSDB2 Stage
Moderators: chulett, rschirm, roy
-
- Premium Member
- Posts: 41
- Joined: Fri Jun 04, 2004 5:52 am
- Location: Bangalore
-
- Premium Member
- Posts: 41
- Joined: Fri Jun 04, 2004 5:52 am
- Location: Bangalore
I don't have access to DB2, so not that familiar with its setup. Have you followed all of the necessary configuration steps outlined in the Plug-in Installation and Configuration Guide for the stage? Have you stopped and restarted DataStage after you made the dsenv changes?
I would think there is more to the error than that - doesn't it tell you which object it couldn't load?
I would think there is more to the error than that - doesn't it tell you which object it couldn't load?
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
where did you specify the LIBPATH. in dsenv or environmental variable level. If you do not specify the in DSENV you will not be able to view data by view data tab but will be able to run the job.
M.T.Anwer
The day the child realizes that all adults are imperfect he becomes an adolescent;
the day he forgives them, he becomes an adult; the day he forgives himself, he becomes wise.
-Aiden Nowlan
The day the child realizes that all adults are imperfect he becomes an adolescent;
the day he forgives them, he becomes an adult; the day he forgives himself, he becomes wise.
-Aiden Nowlan