Hi there,
I have some parameters defined in Sequence, but I am not getting the right syntax when passing them through to the jobs in the sequence.
Any ideas about the right syntax?
Thanks
How to pass the parameters to a job
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 3593
- Joined: Thu Jan 23, 2003 5:25 pm
- Location: Australia, Melbourne
- Contact:
Have you used the "Insert Parameter Value" button on the job activity stage?
Certus Solutions
Blog: Tooling Around in the InfoSphere
Twitter: @vmcburney
LinkedIn:Vincent McBurney LinkedIn
Blog: Tooling Around in the InfoSphere
Twitter: @vmcburney
LinkedIn:Vincent McBurney LinkedIn
-
- Participant
- Posts: 437
- Joined: Fri Oct 21, 2005 10:00 pm
The insert parameter value should work. Do the data types match from the sequence to the job? Is the parameter an environmental parameter?
What is the exact verbage it is giving you for an error?
What is the exact verbage it is giving you for an error?
Keith Williams
keith@peacefieldinc.com
keith@peacefieldinc.com
Yes, it should work just fine. Perhaps there is a fundamental mismatch of parameter types at work here... as noted, please post the exact 'syntax complaint' you are getting, that and the parameter types involved should help figure out what is going on.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers