Iam testing a re-startable sequencer job which has one job activity and a routine activity. In the job activity, the Execution action is - Reset if required, then run.
Iam running the re-startable sequencer job from the command line using dsjob.
When the sequencer aborts for the very first time the output from the command line is as follows
Code: Select all
Waiting for job...
Finished waiting for job
Job Status : (3)
Status code = 3
Code: Select all
Error running job
Status code = -14 DSJE_TIMEOUT
I have already searched the forum but the search results reveal that the Inactivity Timeout should be increased. But in my case it is a very simple job and it hardly takes seconds to report either success/failure.
I would like to know why dsjob is not showing the same status as the Director and what must be done to get the correct status of 3 instead of -14.
Thanks in advance.
Rich