Hi
I have been able to reset the value using the "ExecuteTCl" at the Before Stage Subroutine.
However while trying the EXECUTE command using BASIC code in the Job Control i havent been able to achieve the same.
Do i have to Open the SDKSequence file before issuing an EXECUTE command to peform the UPDATE
Any ex. code snippets?
Thanks in advance
Resetting KeyMgmt Value
Moderators: chulett, rschirm, roy
-
- Premium Member
- Posts: 68
- Joined: Sat Feb 05, 2005 4:59 am
- Location: India
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
"Do i have to Open the SDKSequence file before issuing an EXECUTE command to peform the UPDATE ?"
Depends what command you use to perform the update. If it's SQL, the answer is no.
Depends what command you use to perform the update. If it's SQL, the answer is no.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Premium Member
- Posts: 68
- Joined: Sat Feb 05, 2005 4:59 am
- Location: India