How to clean up the particular job
Moderators: chulett, rschirm, roy
How to clean up the particular job
How to clean up the particular job in the project
-
- Premium Member
- Posts: 385
- Joined: Tue Oct 07, 2003 4:55 am
You can't (or shouldn't) start this daemon; if you run it as supervisor you will just sit there for 15 minutes until it wakes up. Edit the file dsdlockd.config and turn it on (start=1) and it will automatically get started the next time you start DataStage. The config file also lets you change the default interval from the factory settings of 900 seconds.
-
- Premium Member
- Posts: 385
- Joined: Tue Oct 07, 2003 4:55 am
Amos,
yes & yes. If you have frequent cases where jobs are locked even though they shouldn't be then you might bring the time down to 10 minutes (600). I don't know why the installation default is to have this turned off, it is useful and saves people (inadvertantly) doing "kill -9"s in the hopes of getting jobs running again -- this way you can take a coffee break and have the system clear it up for you.
yes & yes. If you have frequent cases where jobs are locked even though they shouldn't be then you might bring the time down to 10 minutes (600). I don't know why the installation default is to have this turned off, it is useful and saves people (inadvertantly) doing "kill -9"s in the hopes of getting jobs running again -- this way you can take a coffee break and have the system clear it up for you.