Hi,
Is there any way to automatically reset and start the job on any abort or failure. That can reduce a bit of manual intevention into the system.
will the batch job that sequence these can handle them without going on aborted state.
Is there any way look the log details other then director. Is these mesages saved in any files or tables. If so where can i find them.
Job Abort
Moderators: chulett, rschirm, roy
VasanthRM,
you can specify an automated reset-before-run when calling a job activity in a sequence. If you start the jobs from outside of DataStage from a command line you can use the -mode reset instead of -mode normal to reset the status before running a job.
The subject of job logs has been handled exhaustively in many posts on this forum. Using the search facility will give you a lot of detailed information.
you can specify an automated reset-before-run when calling a job activity in a sequence. If you start the jobs from outside of DataStage from a command line you can use the -mode reset instead of -mode normal to reset the status before running a job.
The subject of job logs has been handled exhaustively in many posts on this forum. Using the search facility will give you a lot of detailed information.
<a href=http://www.worldcommunitygrid.org/team/ ... TZ9H4CGVP1 target="WCGWin">
</a>
</a>
Hi,
Did you mean just reset before next run (which Arnd Answered) or did you want a way to retry a failed run automatically?
Did you mean just reset before next run (which Arnd Answered) or did you want a way to retry a failed run automatically?
Roy R.
Time is money but when you don't have money time is all you can afford.
Search before posting:)
Join the DataStagers team effort at:
http://www.worldcommunitygrid.org
Time is money but when you don't have money time is all you can afford.
Search before posting:)
Join the DataStagers team effort at:
http://www.worldcommunitygrid.org
-
- Participant
- Posts: 3337
- Joined: Mon Jan 17, 2005 4:49 am
- Location: United Kingdom