Page 1 of 1
Upgrading to 7.5a from 7.01r1
Posted: Mon Dec 05, 2005 4:25 pm
by pavankvk
Hi
we are upgrading as specified..Are there any open issues with this upgrade?
Does it require any code changes?
Posted: Mon Dec 05, 2005 5:12 pm
by vmcburney
No and no.
You should be upgrading to 7.5.1a and not 7.5a. You should think about using the new message handler functionality to remove acceptable warning messages from your production job and you should also look at Sequence job check point and restart though it's an optional code change.
From memory there have been one or two messages about different metadata validation between parallel job versions but I would think you could code fix these if they pop up.