Hi,
When I run a job, the log shows the number of rows inserted into the table concatenated by brackets.
If I click on the log it is showing the number of records too.
Earlier it used to show the number of records inserted and records updated directly in the log.
Is there any parameter that we need to set so that we can see the log in detail.
Thanks,
Phani
Log in Detail
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Hi,
The following message is found in the log.
ORCL_TGT_Supplier,0: Records inserted: 3,281 (........)
Once I click on this line I am able to see
ORCL_TGT_Supplier,0: Records inserted: 3,281
Records used for update: 100
Records rejected: 0
Total records: 3381.
So to see the record count that got updated,rejected,inserted do we need to set any properties.
Thanks,
Phani
The following message is found in the log.
ORCL_TGT_Supplier,0: Records inserted: 3,281 (........)
Once I click on this line I am able to see
ORCL_TGT_Supplier,0: Records inserted: 3,281
Records used for update: 100
Records rejected: 0
Total records: 3381.
So to see the record count that got updated,rejected,inserted do we need to set any properties.
Thanks,
Phani
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
The three dots indicate that there is more message.
If you make the field wider you may see more. However, I'm guessing that there are explicit line breaks in the message, which means that only the first line is displayed in Summary view.
This may be a change in behaviour since the previous release; check the readme files that come with the installation media to see whether such is the case.
As far as I am aware there is no parameter that you can set to change the way that logging of this kind of message works. If you were feeling like a challenge, you might create a message handler that stripped out the line breaks!
If you make the field wider you may see more. However, I'm guessing that there are explicit line breaks in the message, which means that only the first line is displayed in Summary view.
This may be a change in behaviour since the previous release; check the readme files that come with the installation media to see whether such is the case.
As far as I am aware there is no parameter that you can set to change the way that logging of this kind of message works. If you were feeling like a challenge, you might create a message handler that stripped out the line breaks!
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.