Page 1 of 1
Would it be possible to load data dynamically into salesforc
Posted: Mon Jun 01, 2015 6:11 pm
by mystuff
Hi,
I am trying to see if its possible to load data dymanically from sequential file to salesforce with RCP enabled.
Sequential file ( with schema file) ---> salesforce plug in.
Re: Would it be possible to load data dynamically into sales
Posted: Mon Jun 01, 2015 7:39 pm
by rkashyap
Probably not. We have been advised that current versions of salesforce pack (1.501 and 1.502) do not support RCP.
Posted: Tue Jun 02, 2015 1:43 am
by ray.wurlod
The load side probably not, as noted, but you could certainly use RCP on the read side. You would have to make very sure that, at whatever point you transition to not using RCP (possibly a Transformer or Copy stage) that you have sufficient columns named identically to those required on the output.
Posted: Tue Jun 02, 2015 9:07 am
by rkashyap
We had reported that RCP is not working on SFDC pack to our service provider and were advisedRCP is not currently supported in the SFDC Pack. The bug is that the button/checkbox should not be presented.Currently we have a PMR open for this issue.
Please note that we have installed Solaris version of SFDC pack. Apparently SFDC pack on other OS supports some features that Solaris one does not (eg Existing SFDC patch on Linux supports API version 32 vs 27 on Solaris).
Posted: Tue Jun 02, 2015 9:18 am
by chulett
You do realize that the correction to the bug will be the removal of that RCP checkbox, yes?
Posted: Tue Jun 02, 2015 9:21 am
by rkashyap
yes.
Posted: Tue Jun 02, 2015 9:30 am
by chulett
