Oracle Connector Warning

RK72 · Post by **RK72** » Thu Feb 28, 2013 9:53 am

Hi
I am getting a warning when using oracle connector

The connector was configured to run in parallel mode on 8 nodes, but the partitioned reads were not enabled. The connector will run in sequential mode.

Then the job is getting aborted with error as

Parallel job reports failure (code 256)

Please can you tell me what the problem is?

Thanks

jwiles · Post by **jwiles** » Thu Feb 28, 2013 10:10 am

A quick search in the forum for the failure code turns up a couple of threads that may be related. Also, a Google search for the failure code turns up at least one IBM technote concerning the failure code. If neither result is applicable to your situation, you may wish to contact your official support provider.

Regards,