Page 1 of 1
vertical pivot
Posted: Sat Oct 02, 2010 8:30 am
by agpt
How do we do vertical pivot because only pivot type available in pivot enterprise stage is horizontal pivot?
Posted: Sat Oct 02, 2010 9:46 am
by chulett
It has been mentioned here quite a bit, so do an exact search for "vertical pivot" and troll through what comes up. Yes, you will find a lot of matches to posts with this exact same advice to search in them, keep on going and you'll (eventually) find the wheat amongst the chaff.
Posted: Sat Oct 02, 2010 9:50 am
by chulett
Since we just went through this recently with someone else, here's one I knew I could find. As noted, there are other examples out there.
viewtopic.php?t=136037
Posted: Sat Oct 02, 2010 9:56 am
by agpt
Thanks Craig!!!!!!!
I would look into the same.
Re: vertical pivot
Posted: Sat Oct 02, 2010 11:44 am
by Mike
agpt wrote:... only pivot type available in pivot enterprise stage is horizontal pivot?
Have you checked the stage or are you relying on the pdf documentation?
I'm finally getting a chance to look at 8.1.2 and haven't test driven the pivot enterprise stage yet. I dropped the stage into a job and it has two options for pivot type: Horizontal or Vertical. The Parallel Job Developers Guide pdf, however, states that Horizontal is the only available pivot type.
Mike
Re: vertical pivot
Posted: Sat Oct 02, 2010 11:51 am
by agpt
Mike wrote:agpt wrote:... only pivot type available in pivot enterprise stage is horizontal pivot?
Have you checked the stage or are you relying on the pdf documentation?
I'm finally getting a chance to look at 8.1.2 and haven't test driven the pivot enterprise stage yet. I dropped the stage into a job and it has two options for pivot type: Horizontal or Vertical. The Parallel Job Developers Guide pdf, however, states that Horizontal is the only available pivot type.
Mike
Thanks Mike!!!!
I would check my software as well.
Posted: Sat Oct 02, 2010 3:59 pm
by ray.wurlod
Vertical pivot is allegedly to be available in the PXPivot stage (subject to the usual caveats) in the next version (probably numbered 8.5, subject to other caveats).
Posted: Sat Oct 02, 2010 5:09 pm
by Mike
Yes, it seems that the Pivot Enterprise stage in 8.1.x only does horizontal pivots even though there is a choice presented for pivot type. Even without the vertical pivot, the Pivot Enterprise stage is a nice improvement over the Pivot Plugin stage from 8.0.1.
Mike