Unable to View Datastage Log

makreddy · Post by **makreddy** » Wed Jun 09, 2010 3:27 pm

Hello,
I have a sequencer which is multi instanced. At any point of time 10 instances of that will be running. Now I see that If a particular instance fails, I am unable to view the log of it. It is being over written by other instances.

Is there any way to set that the log is not over written by other instances??

Any help would be appreciated.

Thanks
Aravind

anbu · Post by **anbu** » Wed Jun 09, 2010 3:34 pm

Keep different invocation ids for each 10 instances

makreddy · Post by **makreddy** » Wed Jun 09, 2010 3:39 pm

Thats is what I do. Each has its own invocatio id.

anbu · Post by **anbu** » Wed Jun 09, 2010 3:45 pm

Then you should see 10 sequences with different invocation id and their logs in director

Check whether it is failing because of parameter issue. In that case you will not see logs

makreddy · Post by **makreddy** » Wed Jun 09, 2010 4:22 pm

That is not the case. For example, I have job A with 10 instances (1 to 10). Now, in the director i see the LOGS for only the last 2 runs. ex if has run A.1 and A.2 , i will see it. Now, if A.3 and A.4 are run, i am not able to see the logs of A.1 and A.2.

ray.wurlod · Post by **ray.wurlod** » Wed Jun 09, 2010 4:39 pm

Your auto-purge setting needs to be set to keep not fewer than 10 runs.

makreddy · Post by **makreddy** » Wed Jun 09, 2010 4:58 pm

How do we do this???

chulett · Post by **chulett** » Wed Jun 09, 2010 5:33 pm

How do you do what - change the auto purge settings for a job? The option is there in the same place where you do a manual purge, a radio button from what I recall.