Bulk load issue on DB2 Connector Stage
Posted: Fri Apr 16, 2010 2:30 pm
When Bulk load is Load-replaced, I am getting an error message as as shown below:
Db_Acs_Med_Filter_Insert: [IIS-CONN-DB2-000437] The connector cannot be selected as partitioner or the Write mode set to Bulk load with more than one node in the environment configuration when the table action is Create or Replace and the Create statement is generated at runtime. (CC_DB2Connection::connect, file CC_DB2Connection.cpp, line 558)
The input to the Bulk Load stage was specified as Auto partition using 8-node partitioning (even tried 40-node partition) in Config File. I got different errors/discrepancies that can be found in Director logs:
Pls help.
Regards,
DSFreddie
Db_Acs_Med_Filter_Insert: [IIS-CONN-DB2-000437] The connector cannot be selected as partitioner or the Write mode set to Bulk load with more than one node in the environment configuration when the table action is Create or Replace and the Create statement is generated at runtime. (CC_DB2Connection::connect, file CC_DB2Connection.cpp, line 558)
The input to the Bulk Load stage was specified as Auto partition using 8-node partitioning (even tried 40-node partition) in Config File. I got different errors/discrepancies that can be found in Director logs:
Pls help.
Regards,
DSFreddie