MQ Connector stage does not display the properties
Posted: Fri Apr 16, 2010 11:42 am
Hi,
I am using 8.1 and I am writing to write a message to a remote queue using the MQ Connector stage. I am unable to see the properties for the connector stage when I wanted some configuration changes. When I faced the issue before, I uninstalled 8.1 client and then reinstalled it and it started showing the properties (Once I reinstalled the fix pack and once it worked without fixpack installation !) . Today again the properties page is not showing up. Is there a permanent fix for this behavior?
Thanks a lot.
Sumesh
I am using 8.1 and I am writing to write a message to a remote queue using the MQ Connector stage. I am unable to see the properties for the connector stage when I wanted some configuration changes. When I faced the issue before, I uninstalled 8.1 client and then reinstalled it and it started showing the properties (Once I reinstalled the fix pack and once it worked without fixpack installation !) . Today again the properties page is not showing up. Is there a permanent fix for this behavior?
Thanks a lot.
Sumesh