MQ Connector stage does not display the properties

Post questions here relative to DataStage Enterprise/PX Edition for such areas as Parallel job design, Parallel datasets, BuildOps, Wrappers, etc.

Moderators: chulett, rschirm, roy

Post Reply
sumesh.abraham
Participant
Posts: 153
Joined: Thu May 11, 2006 1:52 am
Location: Bangalore

MQ Connector stage does not display the properties

Post by sumesh.abraham »

Hi,

I am using 8.1 and I am writing to write a message to a remote queue using the MQ Connector stage. I am unable to see the properties for the connector stage when I wanted some configuration changes. When I faced the issue before, I uninstalled 8.1 client and then reinstalled it and it started showing the properties (Once I reinstalled the fix pack and once it worked without fixpack installation !) . Today again the properties page is not showing up. Is there a permanent fix for this behavior?

Thanks a lot.
Sumesh
Top
Post Reply

Return to “IBM<sup>®</sup> DataStage Enterprise Edition (Formerly Parallel Extender/PX)”