Page 1 of 1
Conditional lookup in Lookup stage
Posted: Thu Apr 01, 2010 2:38 pm
by Suman
While doing conditional lookup sometimes after right click the input columns show disabled. When the lookup stage id replaced with a new lookup stage it enables the input columns. Is there any reason why sometimes it shows as disabled and sometimes enables.
Regards,
Suman
Posted: Thu Apr 01, 2010 4:15 pm
by ray.wurlod
No.
Does this happen only on your computer, or for everyone at your site?
If it's just yours, try re-installing the DataStage client.
Posted: Fri Apr 02, 2010 11:00 am
by Suman
ray.wurlod wrote:No.
Does this happen only on your computer, or for everyone at your site?
If it's just yours, try re-installing the DataStage client. ...
This is for all others not only with me.
Regards,
Suman
Posted: Fri Apr 02, 2010 9:13 pm
by chulett
Then it sounds bug-like to me. What exact 7.x version are you running?
Posted: Sat Apr 03, 2010 3:15 pm
by Suman
chulett wrote:Then it sounds bug-like to me. What exact 7.x version are you running? ...
The client version is 7.5.1.
Regards,
Suman
Posted: Sat Apr 03, 2010 3:54 pm
by chulett
OK, they did go to 7.5.3 before moving to 8.x, probably worth asking your support provider if it's known and fixed in a later release.