Post questions here relative to DataStage Enterprise/PX Edition for such areas as Parallel job design, Parallel datasets, BuildOps, Wrappers, etc.
Moderators: chulett , rschirm , roy
Suman
Participant
Posts: 53 Joined: Thu Oct 07, 2004 8:28 am
Post
by Suman Thu Apr 01, 2010 2:38 pm
While doing conditional lookup sometimes after right click the input columns show disabled. When the lookup stage id replaced with a new lookup stage it enables the input columns. Is there any reason why sometimes it shows as disabled and sometimes enables.
ray.wurlod
Participant
Posts: 54607 Joined: Wed Oct 23, 2002 10:52 pmLocation: Sydney, Australia
Contact:
Post
by ray.wurlod Thu Apr 01, 2010 4:15 pm
No.
IBM Software Services Group
Suman
Participant
Posts: 53 Joined: Thu Oct 07, 2004 8:28 am
Post
by Suman Fri Apr 02, 2010 11:00 am
ray.wurlod wrote: No.
This is for all others not only with me.
Regards,
Suman
chulett
Charter Member
Posts: 43085 Joined: Tue Nov 12, 2002 4:34 pmLocation: Denver, CO
Post
by chulett Fri Apr 02, 2010 9:13 pm
Then it sounds bug-like to me. What exact 7.x version are you running?
-craig"You can never have too many knives" -- Logan Nine Fingers
Suman
Participant
Posts: 53 Joined: Thu Oct 07, 2004 8:28 am
Post
by Suman Sat Apr 03, 2010 3:15 pm
chulett wrote: Then it sounds bug-like to me. What exact 7.x version are you running? ...
The client version is 7.5.1.
Regards,
Suman
chulett
Charter Member
Posts: 43085 Joined: Tue Nov 12, 2002 4:34 pmLocation: Denver, CO
Post
by chulett Sat Apr 03, 2010 3:54 pm
OK, they did go to 7.5.3 before moving to 8.x, probably worth asking your support provider if it's known and fixed in a later release.
-craig"You can never have too many knives" -- Logan Nine Fingers
