DSXchange

Hi,
my job compiled and run in designer.but in director if i see view log i am not getting anything page getting blank.any thing i have to enable i checked all but not getting

Thanks

Perhaps you're not looking at the correct log? It happens.

What happens if you run the job from Director?

it showing status if job success then it showing finished like that .if i click on viewlog then it showing blank

Thanks
....

And this is version 7, not 8, yes? And the job status changes like it should to Running and then some form of Finished? What do you see in the Monitor while it runs?

Does the dsjob -logsum command work correctly?