Page 1 of 1
partition symbols
Posted: Wed Jul 22, 2009 12:21 pm
by reachmexyz
Hello all
when i use the same partition for any stage in my job, same symbol is not showing up. There is no symbol on the link.
How can i get the symbols back.
Re: partition symbols
Posted: Wed Jul 22, 2009 12:32 pm
by relati
Is this the only symbol that is not showing up OR none of the symbols are showing up?
Posted: Wed Jul 22, 2009 12:42 pm
by chulett
Make sure you have "Show link marking" enabled under the Diagram toolbar option... which is where 'relati' was going.
Posted: Wed Jul 22, 2009 12:56 pm
by reachmexyz
chulett wrote:Make sure you have "Show link marking" enabled under the Diagram toolbar option... which is where 'relati' was going.
I have checked the toolbar option. it is set.
If i have all the stages partitioning as "same", no symbol is showing up on the links. But if i have one stage partition as Hash and other as same,
then both the partition symbols are visible. Only when all the stages has same partition, nothing is visible.
Posted: Wed Jul 22, 2009 1:20 pm
by dsuser_cai
I think you will not see the Partition symbol in this case. I tried the following.
case1)
RowGenStage---->Transformer----->ODBCStage
in this case the partition for the transformer is "same" and the partition for ODBC is also set to same. I didnt see any partition flag (Link Mark) in the link.
Case2)
RowGenStage---->Transformer----->ODBCStage
in this case the partition for the transformer is "Hash" and the partition for ODBC is set to "same". In this case you will see the partition flags in the link.
Posted: Wed Jul 22, 2009 4:55 pm
by ray.wurlod
No partition symbol is shown if stages on both ends of the link execute in sequential mode.