Page 1 of 1
runLocally() of the operator failed
Posted: Fri Apr 24, 2009 7:46 am
by sreelalpp
Hi,
I am getting the following error message on a lookup stage looking into an SQL Server table through ODBC stage.
"The runLocally() of the operator failed."
What could be the root cause for this ?
ODBC_CO_LOC_GL_V_LKP,0: The runLocally() of the operator failed.
Thanks,
Sreelal
Posted: Fri Apr 24, 2009 10:00 am
by Sainath.Srinivasan
What kind of lookup is it?
Are you able to view data?
Posted: Fri Apr 24, 2009 10:03 am
by sreelalpp
Sainath.Srinivasan wrote:What kind of lookup is it?
Are you able to view data?
It is a normal look up to an SQL Server table and I am able to view data.
The lookup stage has the reference link 'Entire' partition and the input stream auto.
Posted: Fri Apr 24, 2009 10:05 am
by Sainath.Srinivasan
Can you view the data ?
Posted: Fri Apr 24, 2009 10:35 am
by sreelalpp
Sainath.Srinivasan wrote:Can you view the data ?
Yes. I am able. to view data.
Posted: Fri Apr 24, 2009 3:23 pm
by ray.wurlod
What is your "Lookup Failed" rule?
Posted: Tue Apr 28, 2009 6:24 am
by sreelalpp
ray.wurlod wrote:What is your "Lookup Failed" rule? ...
Ray, The lookup failed rule is 'Continue'
and no condition is set.
Posted: Tue Apr 28, 2009 8:21 am
by Sainath.Srinivasan
What if you write a job with source from the ODBC stage?