DSXchange

HI,

i have set the NLS settings for a project as NONE.
when i see the NLS settings in all the job it shows project default(none) selected by default. but the job fails to run with this default settings.
But the jobs run fine when i change the NLS settings from Project Default(none) to NONE.

What can be the reason for this. what is the difference between choosing NONE and Project default(NONE)?

NONE is a pseudo-map, not a real map. Thus there is no actual map for it to default to. This generates the error.

hi ,

Is there any way to change the NLS settings of all the jobs in a project from Default(NONE) to NONE at once?
Presently i have to go to each job manually and make the changes.