Page 1 of 1
Unix commands on 8.0
Posted: Sat Jun 21, 2008 8:52 am
by satya99
Hi,
How can i run unix commands in windows in version 8.0
Thanks
Posted: Sat Jun 21, 2008 8:56 am
by ArndW
Aren't the MKS Toolkit components installed automatically anymore?
Posted: Sat Jun 21, 2008 9:38 am
by satya99
ArndW wrote:Aren't the MKS Toolkit components installed automatically anymore? ...
Its installed, But the question is how to get into unix windows.
Posted: Sat Jun 21, 2008 9:43 am
by shiva459
open command prompt on windows and enter sh, you will get $ prompt - you are all set.
Posted: Sat Jun 21, 2008 9:45 am
by shiva459
apologies.. you do not even have to do what I said below. Just go to windows command prompt and you can run all unix commands provided MKS is installed