DSXchange

Posted: **Wed Jun 04, 2008 4:49 am**

Hi,

We are facing a peculiar problem with sequencers. The issue is that for some job activities the parameters go missing even after a successful run of the sequencer. The sequencer goes into Uncompiled state. Is this a bug in 8.0.

Thanks,
Prasanna

Posted: **Wed Jun 04, 2008 5:05 am**

We have encountered issues with Parameter Sets at V8 to which we received a client-side patch; but we never saw the "uncompiled" state problem.

Posted: **Wed Jun 04, 2008 6:37 am**

ArndW wrote:We have encountered issues with Parameter Sets at V8 to which we received a client-side patch; but we never saw the "uncompiled" state problem.

Hi ArndW,

Thanks for the response.We are actually using a list of parameters and not a parameter set. Can you please elaborate the issue faced.Please let me know if the patch is applicable to parameters too.

Thanks

Posted: **Wed Jun 04, 2008 7:11 am**

The patch we needed was only applicable to V8 Parameter Sets and does not apply to normal parameters.

DSXchange

Sequencer job actvy parameters missing after successful run

Sequencer job actvy parameters missing after successful run