DSXchange

Posted: **Wed Apr 16, 2008 9:50 am**

Hi all.

The Stage and Lookup Condition Tabs is not shown in my Lookup Stage. Also, the Input tab is not showing.

I have the Lookup Stage with three links, i.e., output, reference, and input. The job is aborting with the following "StageName,0: Failed a keylookup for record."

I'm need to set the failed rule from "Fail" to "Drop".

When I double click on the stage. Only the output mapping metadata is being displayed. The stage and Input tabs are missing. Can someone help.

Thanks in advance for any help.

Posted: **Wed Apr 16, 2008 1:58 pm**

You should double click on the "Condition" box in the reference metadata box within the lookup stage.

Posted: **Wed Apr 16, 2008 1:59 pm**

sud, I'm in parallel. I'm looking at the documentation and see the tabs there. But it seems to be hidden in the stage.

Posted: **Wed Apr 16, 2008 2:03 pm**

what is hidden? the input links or the place where you want to make "fail then continue"?

Posted: **Wed Apr 16, 2008 3:19 pm**

the place where I want to make "fail then continue"

Posted: **Wed Apr 16, 2008 5:14 pm**

Does your Lookup stage have two inputs?

Posted: **Thu Apr 17, 2008 1:52 am**

the place where I want to make "fail then continue"

to get the place where you can specify this
double cleck the lookup stage then at the top right corner click constraints from too bar. The option will be displayed.

DSXchange

Stage and Lookup Condition Tabs not shown in my Lookup stage

Stage and Lookup Condition Tabs not shown in my Lookup stage

Re: Stage and Lookup Condition Tabs not shown in my Lookup s