DSXchange

Hi,

I done a job as using range partiotion at the compile time its ok,but at the time of running it gives the following error:

Sequential_File_1.DSLink4_Part: Error when checking operator: Opening rangemap [sorter\rangepart.C:361]
main_program: Could not check all operators because of previous error(s) [api\step_rep.C:1128]
main_program: Creation of step finished with status = FAILED [osh.C:1105]

I think the problem is in the range map there i gave the source data file is it correct way or not.
Give me reply for this query.

Regards,
Vinodn

Did you create your range map with the write-range-map stage?

Indeed you must create your range map with this stage type, in a separate job prior to running the job that will use range partitioning.

HI ray,


I will try for this accoring to given.



Thanx

HI ray,


I will try for this accoring to given.



Thanx