Page 1 of 1
DS Engine Statu = Not Running
Posted: Thu Mar 06, 2008 1:35 am
by shin0066
we have a weird situation - when we start ds engine it says engine started but when we see bin/uv -admin -info it say Engine Status = Not Running.
when we do netstat -a | grep dsrpc it shows LISTEN mode.
we are able to log to datastage and run the jobs.
Any idea why un/bin -admin -info not showing correct information?
Thx
Posted: Thu Mar 06, 2008 2:29 am
by ArndW
That is quite strange. What UNIX are you running on? If you execute "$DSHOME/bin/smat -x" do you get output? Also, if you attach to $DSHOME then issue "bin/uvsh" do you get the ">" prompt in UniVerse (if yes, enter "QUIT" to exit.
Posted: Thu Mar 06, 2008 4:19 am
by shin0066
Yes, i can execute $DSHOME/bin/smat -x , it produced all General System Information
I can perform $DSHOME/bin/uvsh to log to Universe.
Thanks
Posted: Thu Mar 06, 2008 4:51 am
by ArndW
I think that you will have to ask your support provider on this one - I've not seen "not running" displayed on a system that is running before.
Posted: Thu Mar 06, 2008 5:59 am
by shin0066
Thanks ArndW, i am trying to reach out IBM. will post the solution and cause once we fix it.
Thx