$APT_Config file changed

Post questions here relative to DataStage Enterprise/PX Edition for such areas as Parallel job design, Parallel datasets, BuildOps, Wrappers, etc.

Moderators: chulett, rschirm, roy

Post Reply
consulting
Participant
Posts: 50
Joined: Fri Dec 21, 2007 3:24 am

$APT_Config file changed

Post by consulting »

i changed default apt_config file when i run the job the following warnings was thrown i think as i changed the default config file it is thrown

1. No disk resources found in "sort" pool or default pool; using /tmp


2. Join_Acct.Acc_Data_Sort,3: No disk resources found in "sort" pool or default pool; using /tmp
balaji
Scope
Premium Member
Premium Member
Posts: 63
Joined: Wed Jun 06, 2007 6:38 am
Location: Chennai

no spcae

Post by Scope »

check your Scratch disk File type spaces .if your scratch disk free space is less than 20 % of total Space, you will get this error. Make it free ,the job will run..
Kumarez
ray.wurlod
Participant
Posts: 54607
Joined: Wed Oct 23, 2002 10:52 pm
Location: Sydney, Australia
Contact:

Post by ray.wurlod »

You have not specified any disk pools.

You should always specify at least a default disk pool (the one with "" as its name). Otherwise there's a lot of use of /tmp that could be avoided. And /tmp typically is not large enough, particularly on Solaris.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Post Reply